AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Airport extreme power cord12/28/2023 ![]() The speed checks should be very similar to the results from the "main" AirPort Extreme. Power up the AirPort Extreme and run a few speed checks. Personally, I prefer the WAN to know at a glance that the Ethernet cable is coming from the other AirPort Extreme. You can connect to the WAN "O" port or any of the LAN ports. Now move the Ebay AirPort Extreme to the remote location where it is needed. When you see the message of Setup Complete, click Done. The next window will look like this example except that you will see another AirPort Extreme displayed Type in a name that you want to call the Ebay AirPort Extreme ![]() The window will look like this except that you will see another AirPort Extreme pictured.not an AirPort Express. Later, you can connect the cable to one of the LAN ports, but I would use the WAN "O" port on the Ebay ExtremeĪirPort Utility will suggest the correct setup to extend the network. Use a short spare Ethernet cable for the setup, so both AirPort Extremes will be close to each other.Ĭonnect the cable from one of the 3 LAN ports on the main AirPort Extreme to the "O" port on the Ebay AirPort Extreme. A bad connector on an Ethernet plug or port will still allow a connection, but the maximum speed will be less than 100 Mbps. Make sure that you are using at least CAT5 or CAT6 Ethernet cable. Leave the AirPort Express powered off and not connected at all for now and start over with a new setup of the AirPort Extreme. You would connect the Ethernet cable from one of the 3 LAN ports on the "main" AirPort Extreme to the WAN "O" port on the Ebay AirPort Extreme. Got that.Ĭonnected ethernet cord to LAN port on Airport Express. Any suggestions would be greatly appreciated. The unit is unplugged and in not connected in any way so I figured it would not have any effect on the set up.ĭo I need to do something else to get it to faster wifi speeds? Not sure what is wrong. I did not - yet - "forget" the original Aiport Express router that shows on Airport Utility. I did update the AirPort Extreme to most current firmware of 7.9.1. This is with the AirPort Extreme directly behind my iMac and wireless. Doesn't make sense as I should be getting much faster speeds. This is the same speed I was getting with the Airport Express, which is slower than the Extreme. I am only getting 90 mbps down and 23 mbps up when testing iMac via OOKLA Speediest website. Everything looks fine in settings, but the speed is not what I should be getting. Set up as "Create wireless network", etc. (I then saw that the used AirPort Express had original person's settings) Proceeded to edit old settings to my set up with my password, names, etc. I did notice in Airport Utility it said something about a "soft reset", but I proceeded forward anyway, wasn't sure what that meant. Then pushed the reset button for 8 seconds and released. Plugged in power cord to AirPort Express, waited a minute. Order of what I did: Connected ethernet cord to LAN port on Airport Express. Purchased used AirPort Extreme off ebay and have connected it to my existing AirPort Extreme via ethernet connection.
0 Comments
Read More
Leave a Reply. |